FPGA+外部PHY+SFP光口问题

右手边 · 发表于 2015-7-16 19:04:13

sfp的6脚需接地

saigu · 发表于 2015-7-16 19:42:52

回复 18# livelei

嗯，谢谢！

右手边 · 发表于 2015-7-16 19:45:39

PHY有一部分引脚需要悬空，光部分调同了吗

saigu · 发表于 2015-7-16 19:52:47

本帖最后由 saigu 于 2015-7-16 19:53 编辑

回复 20# 右手边

1. 是我原理图上的C113吗？从手册上看是需要连电容的。

QQ图片20150716195127.png

2.6脚是MOD-DEF0，从手册上看，这个引脚在SFP内部是接地的，然后外面是直接连FPGA，然后拉高，如果有SFP插进来，这个引脚电压就会为0，说明有设备在了。

QQ图片20150716195257.png

右手边 · 发表于 2015-7-16 20:05:03

第二句话你看看，no connect。它是有两种供电方式。

anovickis · 发表于 2015-7-17 03:45:52

if LOS is high you are not driving laser on remote end or optical cable wrong
make sure other end is ON

Also check power pins L3/L4/L5/L6 to your SFP cage
Is the U11/U8 pattern correct on the PCB ?

strictly you need 1000-X not SGMII but that's another issue not related

anovickis · 发表于 2015-7-17 03:48:55

one other thing - is this optical SFP or "RJ45 SFP" ?

on Copper RJ45 SFP's the LOS does not work exactly as one can expect, it's either always ON or wired to internal PHY link status

右手边 · 发表于 2015-7-17 08:29:08

相信你能调通，到时什么原因说下

saigu · 发表于 2015-7-17 08:47:18

回复 28# 右手边

谢谢，到时候调通肯定会贴出原因的。

saigu · 发表于 2015-7-17 09:20:57

回复 26# anovickis

How can i drive the laser on remote end? Two PCBs are connected with SFP which is powered by PCB, and does it means that the end is on?
RJ-45 SFP is been tested and two PCBs can communicate with each other. When i change the RJ-45 sfp with optical sfp, the two PCBs can not work.

账号		自动登录	找回密码
密码			注册

[求助] FPGA+外部PHY+SFP光口问题

浏览过的版块

站长推荐 /1